I've been shafted by Ted Teten:
Spicer joints with grease fittings:
Shot of the clearance:
Cool "down the shaft" shot:
DP bolted up with gasket:
Has anyone found this gasket locally? As in not through Phase2, Enjuku, etc.? I looked a half a dozen places for one including muffler shops and NAPA, and no one had anything.
Making my own exhaust hanger bracket out of 1/4" flat stock:
I would have preferred thinner material or aluminum, but this was the widest thing my dad had laying around. In case you're curious, I was unable to use OE parts because my trans mount is essentially a block of urethane without a suitable way to latch onto. A friend recommended I drill through the trans crossmember, but I wasn't comfortable with that. I suppose it wouldn't have seriously affected the structural integrity, but I'd prefer to put time into a bracket instead of altering crossmember.
OE front brake line compared to the Russell one:
Line installed:
In retropsect, installing it starting at the caliper might have been easier.
New clips and old:
New clips installed:
Completely assembled:
Overflow reservoir bracket:
