BusinessMan_24

3-19-09

I was missing the shifter stabilizer bar bracket on the transmission so I had someone from Canada ship me one. This is the Gti-r shifter and as you can see it works perfect.


In order to get the shifter stabilizer bar on the bracket you have to modify part of the tunnel. If you look at the floor with the carpet out you can see it goes into the tunnel more where you need to cut. After you cut it just weld a new piece in so it continues at the same gap as earlier in the tunnel. I didn't take a before picture but if you look at it you will understand what I mean.


I bolted up the drive shaft so I can figure out were the rear sub frame needs to be mounted. The support brackets for the drive shaft are not mounted yet.

__________________

91 Nissan NX2000-AWD & Bostd
51 Mercury 4dr-Cruiser
95 Nissan 200sx se-r(Daily Driver)