3-23-09
Worked on filling in the holes I cut in the floor for the drive shaft. Made my box, welded it in place then drilled my hole. After you drill your hole you can put the bolt in and finger tighten the drive shaft up. Once its finger tight you can weld it in place. This way the bolt will be the correct way when its bolted in place.
Had to modify the passenger seat bracket a bit. You can still get all 3 bolts in but the 3rd one won't really do a lot anymore.
On the driver side you just have to drill your hole and then get it down to bare metal so you can weld the bolt in place.
I picked up some 3M seam sealer to go over top of all my welds inside the car with.
I’ll have to try to kick it up a couple notches and get a lot more done in a day. Doesn’t seem like I’ve accomplished much lately.
