|
I haven't done it personally, but I have done the clutch on my 240. Given what I've seen, all you would need is a load leveler to "tip" the engine as you pull it out.
A load leveler is a threaded shaft device that allows you to shift the load and effectivly change the angle that the engine hangs.
As you would rase the engine, you would slowly start to angle it back. It is possible, but it will be a bit tricky. It's probably easier, and safer, to drop the tranny first.
Use your best judgment.
-Alex
__________________
"What about the twinkie?"
|
