4-13-09
Here is the RSTB, nice and simple. As you can see I modified my strut tower brackets a bit from the previous picture.
I then started on the extra bracing in back. First I welded in a piece of 3/16 thick flat stock between the square tubing.
Then I figured out the angle I would have to cut my round tubing so it would sit flat.
After the angles were cut I tacked it to the strut bar mounting point and the bracket which gets bolted to the floor.
The bracket will sit on top of the new floor and be bolted down with the sub frame bolt.
Tomorrow I will finish up the other cross bar as well as figure out a way to branch it to the front bolts.
