SR20 Forum - View Single Post - Help with @#$!%^& Tsuru's
Nissan SR20 Forum Nissan SR20 Forum Header Right
HomeForumGalleryClassifiedsAbout UsAdvertiseContact Us

Welcome to the SR20 Forum forums.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us.

» Log in
User Name:

Password:

Not a member yet?
Register Now!
» Auto Insurance
» Featured Product
» Wheel & Tire Center

Go Back   SR20 Forum



Sr20Forum.com is the premier Nissan SR20 Forum on the internet. Registered Users do not see the above ads.
View Single Post
Old 11-22-2004, 11:57 AM   #6 (permalink)
gpser96
SE-R Lightweight

 
Join Date: Aug 2000
Location: Pittsburgh PA

Quote:
Originally Posted by NismoSER
Ack, I can't remember which one is which and I just dropped my SE-R off at the paint shop where it will be for a month.

I do remember that the green wire coming off of the headlight harness was the ground. To get this right, you'll need a voltmeter to verify which wire does what. It sounds like you did exactly what I did which was to follow the NPM instructions but I think Nissan changed up the wiring colors on the harness for the new Tsuru headlights.

You'll notice the way you have it wired up now that when you have your "low" beams on, the power wire is only getting somewhere around 7 or 8 volts. Since the ground and high beam wires are reversed, its actually grounding through the high beam positive wire, since that is looping through the bulb to the ground wire. This is also why your high beam indicator glows when the low beams are on.

When you switch to the high beams, it takes that ground loop thing out of the equation, with the ground getting the power and the high beam positive acting as the ground..your high beams now look normal. Also, the high beams are getting a full 12 volts.

Best way to figure this out without a voltmeter: Turn on your headlights and switch to high beams. Disconnect 1 of the 3 harness wires until the light goes out. Keep note of that, we'll call wire A (main wire A for the main harness is soldered/connected to headlight A for the headlight harness). Reconnect it so that the light goes back on. Disconnect 1 of the other 2 wires until the light goes out again. Call that wire B (main wire B for main harness is soldered/connected to headlight B for the headlight harness). Now swap the wires. Main wire A from the main harness should go to headlight B, and headlight A will go to main wire B. I really wish I had the colors written down because that would make all of this so much easier. LOL

How you have it (and how I had it....)
headlight side low beam ---> low beam
headlight side high beam ---> ground
headlight side Ground ---> high beam

Just swap those last two around!
Thank you. I will try it this way, the wire colors would make it so much easier. I'll bump and may be someone can fill in the wire colors for us.!!
gpser96 is offline   Reply With Quote
 
Powered by vBadvanced CMPS v3.2.2

All times are GMT -4. The time now is 11:07 AM.



Powered by vBulletin® Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
© The SR20 Forum - Content from this site may not be used without permission