Quote:
|
Originally Posted by SR20Turbofreak
DOH! i for got about that... the P11 throw out fork uses a bushing at the bottom of the shaft. the P10, B13 doesn't use a bushing. You need to somehow get the bushing out of there or grind the shaft down...
Thanks for reminding me of this. I think i just pushed the bushing out of the hole. don't remember how but i did..
|
It was cast into the bell housing on the trans I used. I tried beating on it a bit but it didn't budge. Its really not hard to grind the shaft down though. A write up coming soon I swear.
