prolly fixin to do a custom exhaust on my g20 (3 inch) if any one has done this before what bends should i buy? how many hangers etc. thanks

prolly fixin to do a custom exhaust on my g20 (3 inch) if any one has done this before what bends should i buy? how many hangers etc. thanks

My buddy has a 2.5 inch exhaust on his turbo'd G20....If I recall, it doesn't require a lot of bends. Though I can't tell you what angles or anything.

2 90* bends and 1 180* bend (or 2 180* bends) and some straight pipe would be plenty.

it comes stright out of the cat, makes a 90* bend towards the passenger side, then makes another 90* bend towards the rear. then it makes a ~45* bend to clear the axle, then another ~45* back down, then another 45* to go straight back to the muffler.

i could make you one but i dont have a p10 to test fit it on....it should only take a few bends.

My friend bought the 3in. piping kit for a B13 and it fit perfectly on his G20. So just copy the B13 bends and you should be straight.

Make it a side exit, even less piping