How do you connect the conversion electrical connector/adapter(brown,gray,green wires) to the stock driver side harness. They do not match. All help will be appreciated.

Wait until tomorrow and I'll get my notes of when I installed mine. I know that I have the wire colors written down somewhere.

One thing to note on this. The '98 200s and the '99 Sentras had different headlight bulbs than the other B14s. I know this because a friend was putting NisKnacks projectors in his '99, and the high beams were always on. When he would hit the high beams, the fuse would blow. When I got there, I looked at the instructions, and his wiring. Following directions fixed the problem.

The connector that came on my high beam, low beam, and ground wires does not match my stock driver side headlight connector. Anymore advice? Just one more step, and install will be complete

Well I had the same problem before . You have to go get some connectors from autozone. It is a female plug that plugs into your projector headlight harness and splice it to your factory headlight harness. Then try to figure out the color coding. Just figure out the way the wires are distributed to the light. If I remember right, the green wire on the projectors would be the ground. Let me know if you need some more info. If you need to, I'll check out my car and tell you exactly how the color coding is.

Bryan

download the projector install document (the .ppt) from my yahoo briefcase at http://briefcase.yahoo.com/domiguy (in the Shared folder). There are pictures there that tell you what wires go where... good luck

I knows this is old but does anyone know what wire connects to what wire?

I knows this is old but does anyone know what wire connects to what wire?

This is the method I used when wiring the projectors into my 98 SE

http://www.nissanforums.com/showthread.php?s=&threadid=10754

It is much simpler and cleaner then splicing all the wires. Check it out.