How Much did you pay. I had my housing boxed and ready to go to Extrude hone and they wanted 200$ each for mine and my friends. This seems a little high to me. I was looking around 125 or so each. If you have had it done, which extrude hone did you send it to. Who did you speak to, and how much did you pay. Thanks for your help.

Danny

BTW a phone number to whoever you talked to would be nice.

Originally posted by TurboMiata
How Much did you pay. I had my housing boxed and ready to go to Extrude hone and they wanted 200$ each for mine and my friends. This seems a little high to me. I was looking around 125 or so each. If you have had it done, which extrude hone did you send it to. Who did you speak to, and how much did you pay. Thanks for your help.

Danny

BTW a phone number to whoever you talked to would be nice.

They should only be about $75.00-$80.00 epr Exhaust housing to get done. I just recieved my exhaust housing from them yesterday. It will be at HPC tomorrow to get coated. If they tell you it will be $200.00, send it to me and I will send it in to get done thourgh APEX.

It cost me $75 to get the turbine housing for my GT30/37 done.

Where did yall ship them out to. The place I talked to was in PA, Are yall shipping them to CA??

Thanks

BTW If I do go through you what is you address so I can send it if it comes to that. BTW what was the turn around time on it?

Danny

Originally posted by TurboMiata
Where did yall ship them out to. The place I talked to was in PA, Are yall shipping them to CA??

Thanks

BTW If I do go through you what is you address so I can send it if it comes to that. BTW what was the turn around time on it?

Danny

Extrude Hone
8800 Somerset Blvd.
Paramount, CA 90723
562-531-2976

If they still give you the run around, you can ship it to me @

Louis Anaya
APEX Motorsports
1425 East University Drive, Suite 107
Tempe, AZ 85281

I will then ship it out, get it done, and ship it back to you!

Thanks Louis But I called them and they said 75. They will ship out tomorrow. Thanks again for the offer and the help.

BTW do you plan on going to any Texas Drag events? I should be bringing the miata out to some.

Danny

I've heard of some people getting the compressor side extrude honed too.

Was the $200 price possibly for the exhaust and the compressor housings? Because thats the price I've heard for getting both pieces done.

I made sure he was clear. He was very clear that it was just the "Cast Iron Exhaust housing"

hmm.. OK ;)


at least I know which EH to go to when I need it done now. :) Thanks for the info.

uuuh Question--to those who have taken your turbos apart to get the housings EH'ed, Do you guys already have a Gasket for when you put it back together? Where did you get the gasket from? And do you have a part # and how much?
thanks
Lamar

There is not gasket from the Turbine housing to the center section. If you are talking about the manifold to turbo gasket, then a T25 uses a 300ZX (Last gen), gasket from nissan. A T3 Gasket can be found from any turbo shop. The downpipe gasket I am not sure on the T25, and the T3 downpipe gasket is the same deal as the inlet, just get it at any turbo shop. Very often turbo gaskets are re useable because they are solid, or layered metal gaskets.

Danny

ok cool
thanks for the reply