My 96 se-r ps pump has nothing to bolt up to on the avenir block. The bottom moutning bracket bolts up to the bracket fine, but the top bracket that can adjust the tension on the pulley doesnt bolt up. On the lowport DE bock there were two holes next to the water pump, thats where the bracket bolted too, my avenir doesnt hve those 2 holes so what should i do?

My 96 se-r ps pump has nothing to bolt up to on the avenir block. The bottom moutning bracket bolts up to the bracket fine, but the top bracket that can adjust the tension on the pulley doesnt bolt up. On the lowport DE bock there were two holes next to the water pump, thats where the bracket bolted too, my avenir doesnt hve those 2 holes so what should i do?

Your Aveneir has them please look again.

I just checked, i seriously cnat see them and i *** that when i tried bolting up my ps pump when the motor was out we dindt see them either. My car is going on the lift some time next week and im going to see if they can find where it bolts too.

They should be there though right?

When I installed my motor it had the holes.

I still dont think they are there, i checked it out today for like 20 mintues, I went to my friends house and checked out his highport sr and the ps belt tensioner bracket bolts up through the bolts that bolt the water pump to the block. That finally explains it. Thanks for the help though.

I'm using a lowport PS pump on a highport. The only thing i had to change was the 90 degree fitting on it. Had to use a B13 one.

i had no problems. all from my 91

I'm using a lowport PS pump on a highport. The only thing i had to change was the 90 degree fitting on it. Had to use a B13 one.


Thats probably a good idea, my B14 PS hose leaks on my highport.

~ Marcus