yes it runs and good to. now I got to wash it. any one inthe area wanna go cruise, I wanna beat up on some hondas.

Originally posted by NX-t
yes it runs and good to. now I got to wash it. any one inthe area wanna go cruise, I wanna beat up on some hondas.


Hmmm...if you wern't so far away I'd go ridin *** ya....you going to the convention? Hope to see you there!

~Ryan

I wish I could go, but between school and my job I don't think I'll make it.

I would, but i just broke my clutch lever it is going to suck to fix

how in the world did you break that?? you mean the lever that is on the top side of the tranny right?

Yea it is the lever that connects to the tranny. I have no idea how i broke it. A few people said that they have broken one. The good thing is that it only cost about $35, the bad thing is a have to pull the tranny.

interesting break. i just got mine back from the tranny shop, and now i have a working 2nd gear so i'm very excited. right now i'm broke, waiting for a new checkcard, and without gas so it looks like no fun for monsoon. :(

your looking fo the controll arm that works the throwout bearings?? I think I have an extra one from the old tranny we took apart, it yours if you want it.

Thanks man but i have allready order one from nissan. Do you have any idea how could reinforce the lever for me so it doesnt break again.

Originally posted by OklahomaBoy
Thanks man but i have allready order one from nissan. Do you have any idea how could reinforce the lever for me so it doesnt break again.

Post a picture of where it broke and I might be able to give you an opinoin...

~Ryan;)

have some one weld plates 1/8" plates across the top and bottom, just notch out were the clutch cagle goes in.