Ok.. due to the fact of my quest of better gas milage after full tune-up and TB cleaning I decided to reground my MAF sensor after the positive feed back. So far this is what I did. PM with any questions.. but this should cover it.
1.) Tools:
10 awg wire. Approx 3 feet.From what I know you can use 10-16. I opt for 10 cause it was laying around collection dust.. plus its nice and think for good conduction.
Razor blade
2 male connectors
1 female connector
1 Round connector
Flathead screwdriver
Wire splicer/cutter
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_27_full.jpg
2.) Location of work space.
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_28_full.jpg
3.) Sensor
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_29_full.jpg
4.) Use screwdriver to push in sensor connector all the way into til it stops.
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_30_full.jpg
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_31_full.jpg
5.) Pull connector towards the firewall. Should come off with a little tug and wiggle.
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_32_full.jpg
6.) From here you want to cut back the electric tape being careful not to cut the wires.
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_33_full.jpg
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_34_full.jpg
7.) In this pic you can cleanly see the 3 wires going to the sensor. The one to be worked on is the CENTER wire. That's center from both sides. ;)
And you want to go ahead and cut that with and splice it.
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_35_full.jpg
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_36_full.jpg
8.) Now you want to use your new ground wire and slpice and attach a male connector to one end.
http://memimage.cardomain.net/member_images/1/web/805000-805999/805495_37_full.jpg