The swap is done (GTiR into 2001 Sentra xe 1.8l)! The engine idles perfectly and all the small issues have been take care of!

One problem remains! I still need a passanger-side axle! I'm almost out of ideas at this point! Here's my setup!

Motor: sr20det
Tranny: 95 G20 w/o ABS w/ LSD

We were able to find a 95 G20 axle for the driver-side and it works perfect, but I can't find a g20 passanger-side axle anywhere (junkyards ect.) so I'm forced to buy from dealer!

My question: will the 95 G20 passanger-side axle fit onto a b15?

Any other ideas are also welcome!

Cheers,
Jaksa

I think you should get a '00 SE axle. Reason being it still has an SE trans, which should have the same splines in the tranny as the GTi-R tranny. And the '00 has the newer knuckles as all the other B15's.

Corey

Yeah I should look into those too! Wish I could get concrete information on the input of the G20 LSD tranny!

Like Corey said, just get an SE axle. This will fit in the B15 hub and fit in the trans. On the passenger side it doesn't matter if its LSD or not, it's the same axle.

Like Corey said, just get an SE axle. This will fit in the B15 hub and fit in the trans. On the passenger side it doesn't matter if its LSD or not, it's the same axle.

I've already picked up a 00-01 Se axle without LSD and the shaft spine is too small! The LSD G20 tranny uses thicker input shafts and the flutes on the end are wider. I'm gonna make a trip down to the dealer and see if they have any LSD axles on hand and compare the spines!

Has anybody with a G20 converted over to a B15 tranny and kept their original axles, or did they get b15 SE axles to go with their new tranny's?