installed emanage this weekend minor problems...

first didnt have power connected right so when i did get it started finally it was rich as all hell, and i think thats the cause of my po172 check engine light.

also... everything is connected right to the best of my knowledge exept that i cant get the e01 screen to display my injector duty cycle of duration, or my ingnition timing, or my engine rpm.

i went threw and did the setup a number of time but still cant get them to read at all. i do have the airflow in and out and throttle percent *** if that helps.

but im really at a loss right now cause i cant figure out if i did something wrong.

other than that the car runs great. any help is appreciated

also installed the 380's at the same time so i dont know if the emanage is compensating for the lager injectors...seeing as i cant read the duty cycle.

tried putting the e01 screen rpm input directly to the rpm wire on the emanage harness and i still have no rpm. now im just confused.

Sorry I can't help you but where did you buy your emanage from?

does your e 01 display anything, I have emanage with an e01 and hooked eveyrhting up. Double check all the harness to the e 01 control box. it sounds like ur e 01 isnt communicating with ur emanage.