Does anyone know what ype of HP range a 50a/r comp and 64 a/r turbine housing GT2835 is capable of. I do not know the trim levels of the wheels. Anyone with some knowledge of the 2835 that came with theses a/r's should have an idea as to what trims.
Rob? I will have part# tomorrow for confirmation.


Thanks Lawrence

This is what I found Rob Cadle discussing in the SE-R archives:

"GT2835: I believe that the following is the spec for this, but I could be wrong: 48,52, or 56 trim 71mm BCI-18C compressor in T-04E housing. 84 or 90 trim UHP turbine cut down from 60mm to 56.5 mm. .64 or .86 A/R turbine housing. BB center section.

GT2835: If this turbo is actually what I described above (check to make sure before you buy), this should be a pretty good turbo. Get the 56 trim compressor wheel and the 90 trim turbine wheel with a .86 A/R turbine housing. This should make good boost by 3500 RPM and should support 375-400 or so wheel hp."

Not too sure if this is relevant to your question but I hope this would lead to some kind of answer.