:confused: I was wondering were do you put or drill the hole for the clutch pedal when doing a auto to manual swap..hook me up here i tried searching and DAMN its hard to find..so pls imfo me here:D

bumppp

if you look under your dash you will have to pull back some of that foam shit and then you will see a raised sqaure part in your fire wall ithe bottom bolt goes in the bottom left corner and the top bolt goes in the right top part and on your clutch pedal assembly look at the top bolt ( its actualy a hole ) but if you go farther up the fire wall you will see a hole where a bolt goes in thats for the top part of the bracket

it seems alot hared than it realy is make a templet and start by puting a bolt in that top hole to line it up


trial and eror is the easyway but dont mes up the holes you only have so much area to work with

if you need a cluctch assembly and brake assembly then i have one coming in the mail just pm me if you need it

will b13 clutch pedal brake pedal shift linkage fit in a b14?

The shift linkage from a b13 will work. but IIRC I had to use the b14 clutch and brake pedals.

what does IIRC mean?

If I Recall Correctly.

You just have to stick it up there and guess. I got it on my first try.

just like i said up there and all the hift linkages work and the pedals all work

I had an old shell outside and I measured from the brake booster holes and use a cable attachment on the drill to get the holesaw at the right angle from the engine bay instead of under the dash...It was interesting and ruined the attachment but not before drilling all the holes