I was all ready to get this thing running after replacing the motor and the clutch disc. The motor would run great but the tranny won't get into gear. I turned the car off, put it into gear then, release the clutch and nothing happens. It seems like the car would not engage at all. Please help. I have the car down for almost 5 weeks now. Thanks .


Bryan

Check the adjustment on your cable. Jacen99se and I just replaced my clutch, plate, disc, bearing and when I first started the car it felt like nothing was there. The cable was too loose. I tightened it and the clutch engaged properly.

Hope this helps out!

When we were done with the swap. (the fucken dumb fuck dude that did the work on my car) Resurfaced my flywheel totally off. Before I knew that, I took it to a tranny shop and they figured it out (for 2 months). They said is was the wrong clutch, so I told the dumb fuck (the fucken dumb fuck dude) to get me a new one then. So he decided to drop off the new clutch (he claimed). Then I called back for a check up, and they again said its the wrong clutch again. So I went there looked at the new clutch (that dude claimed) and He fucken spray painted the mother fucken thing into a different color!!!! Now was I pissed but anyway I could write a novel about his shit work and don't do business with this fool (milwaukee) take it somewhere were you can rely on. So I hope you don't go route cause its a bitch to go through, well I did at least. Also I was charged for a used flywheel and a stock clutch cause everything was a mess. Anyway hope you can figure it out.

Mike