I have a stock GTiR ECU running my Avenir motor.
mods are in my signature if that matters.
i'm pulling a code 11 and a code 34 off my ECU.
i'm just wondering if they are the same as the other codes for the other ECU here
http://www.sr20forum.com/showthread.php?t=96214&highlight=ECU+Trouble+Codes

car runs fine but A/F seems to be all over the place one minute then the next it's fine... mainly at idle it's just all over the damned place. and i've checked for leaks and it's tight now.

TPS prolly

I have a stock GTiR ECU running my Avenir motor.
mods are in my signature if that matters.
i'm pulling a code 11 and a code 34 off my ECU.
i'm just wondering if they are the same as the other codes for the other ECU here
http://www.sr20forum.com/showthread.php?t=96214&highlight=ECU+Trouble+Codes

car runs fine but A/F seems to be all over the place one minute then the next it's fine... mainly at idle it's just all over the damned place. and i've checked for leaks and it's tight now.

Hey you having the same problem too? I was wondering if I was the only guy that was getting that. I have the Original ECU and MaF and I have no idea why this happening.

If your getting code 34, that is the det sensor (knock), and code 11 is the crank angle circuit.

Just confirming that the codes you are getting are corect.

well 34 can go off becuase of too much knock. so more than likely it is just one problem. i asked about the TPS, cause he is using the GTI-R ecu. so i think you would have to swap the TPS wires

can you give more info on swapping the wires?

well i just swapped out my knock sensor with another 1 that i had laying around
and i'm still getting code 11 and code 34