Who besides Mike Smith provides boring and honing with a torque plate specifically for the SR20 block? Mike is very backlogged right now. Any ideas? Thanks.

Rob

Andreas I think has mentioned it in the past. :)

Try Terry at www.ftfmotorsports.com

You could check with Sunbelt in Georgia, but I'm not sure how much time it will take (if they agree to do the work)

http://www.se-r-list.org/archives/2001/2001-06/frm00468.html

770-932-0160

Andreas has mentioned that he has a torque plate. I have used JWT in the past for my boring and honing. Whoever hones it, make sure they plateau hone it...Don't go with a place that uses a dingleberry hone...which is a big drill bit thing with little balls on it.

By the way, how does one get a hold of Mike Smith?

Good luck,