Okay, so I'm finally removing the Midget MSD stand alone from my SR20DET and putting it back to stock. (I have the stock coils/wire harness/ignitor now) and also bought a Accel 300+ CD ignition to put in there as well. According to my Holley manual, the following is the wiring that I should use. I want to confirm that this is correct.

http://img.photobucket.com/albums/v653/houmack/Ignition.jpg

Instead of the megnetic crank pickup, i'll be wiring to cam sensor, and instead of the "coil" i'm wiring to the Ignitor... correct?

MANY THANKS

There is no IGNITOR, stick to the drawing as is.

Check the voltage and signal wave form from the Magnetic Trigger. If you want to use the CAM Sensor, then the voltage from it is 5vdc Digital (Digital Square Wave); it will have to be just what the Mag Trig is for the ECU to recognise it.