The convention is 3 days away.

What are people doing to prepare for the trip? :cheers:

Trying to get the car up and running.

wheels/tires/swaybar/springs/helmet/harness/LTB/tequila/work/work/work

Koyo, Autopower, bank robbery, T28 upgrade, Hotshot fmic pipes, Spearco IC, Progress rear bar, robbery #2, 5 point harness install, stereo install, etc etc and so on and so forth, ad nauseum, ad infinitum, Roger Dildo, in and out.

Install Momo wheel & shift knob & pedals. Amp, speakers and Basslink. Sheesh - I better get going

C

trying to see how i can afford to go.... :dunno:

Drinking heavily.

B13

-Install driver side axle
-shave shifter stabalizer bracket to accomadate b15 trans
-Install fuel pump (walboro)
-install wheel studs (nismo 60mm)
-install suspension (tein)
-oil change
-new plugs
-new fuel filter
-new cap & rotor
-new wires (msd)
-new clutch cable
-detail & wax car

B14

-install f/r progress bars
-detail & wax car
-oil change
-new plugs
-new fuel filter
-new cap & rotor

well thats all i could think of off the top of my head. i am so hyped about the convention. Also i have to try on my race suit i never actually got to ware it. hopefully it fits, gonna wear it on the road course.

what im gonna do is use this post as my check list to make sure i get everything done, my goal is to have everything done atleast a week to 2 weeks before the convention except the oil changes that i would do a few days before.

1. Get on dyno to make sure a/f ratios were good. Check! (Rev It Up Motorsports FTW!)

2. Install new tires. Check!

3. SS braided brake lines that I bought almost 2 years ago, rebuild master cylinder, purchase new Panthers for the track event.

4. Progress rear sway bar

5. Make sure car passes tech inspection.

6. Clean engine bay

7. Detail car and its inherent dent.

8. Get it to the convention and back in one piece.

tune up, wheels, tires, suspension (tein), brake pads if i still have enough money, new rear caliper. Get the car detailed. replace radiator and valve cover gasket. Paint calipers. Replaced front ball joints and es control arm bushings & trying to buy some front and rear strut bars. Also new driver's side tail lamp.
(i'm bringing the b14)

You guys all have your priorities wrong!

You guys all have your priorities wrong!
:confused: :confused: :confused:

You guys all have your priorities wrong!

so what would you do besides drinking?

chicken?

so what would you do besides drinking?

You mean there are other things? Ok, now I'm the :confused: :confused: :confused: one!

My car is in the garage, preparing for the month long detailing. :)

not much. try and get this crossmember prob fixed. helicoil i guess. wait for jwt to send me my turbo chip. fix a punctured tire. and clean her up.

I CANT WAIT !

stratton.

Trying to find a car to drive.

Making sure my car doesn't break right before!!

stressing.

Stupid job, stupid money, stupid nonexistent turbo kit.

im going over that tech list so i know im set to track it.. id idealy like to swap my t25 kit over to my b13 and let my 3rd go back to stock.. but my brother just got rod knock so there goes the weekend.. i dont wanna chance anything this close by going turbo... besides my calum ecu is still being tested or something!?


ps. at least i got my koies and falkens on thou!