MR2Man
05-27-2006, 02:01 PM
Ok, I just pumped my turbo with air where the wastegate line is on the actuator of my ct26 turbo.
Its now in what Im not sure is fully opened, but definitly open position and isnt shutting. Im not sure what this means, if anything, if its operating normally or what, but I was wondering, how do I get it to go back down?
I want it shut when I reinstall the downpipe.
After looking at the MR2 BGB, it says Im not supose to apply more than 11.8 psi of pressure to the wastegate, Im using a bike pump with no gauge and might have applied much more than this, is this why my wastegate is staying open? I hope i didnt break nething.
Its now in what Im not sure is fully opened, but definitly open position and isnt shutting. Im not sure what this means, if anything, if its operating normally or what, but I was wondering, how do I get it to go back down?
I want it shut when I reinstall the downpipe.
After looking at the MR2 BGB, it says Im not supose to apply more than 11.8 psi of pressure to the wastegate, Im using a bike pump with no gauge and might have applied much more than this, is this why my wastegate is staying open? I hope i didnt break nething.