|
Loco 06-02-2006, 08:36 AM Whenever I purge my Zex setup, I can hear it, but don't see the gas. I have it pointed on the bottom of the windsheild. Any suggestions? There are times that I see it, but they are few and far between, and only for a few seconds. I have yet to wire up the bottle heater, so the pressure might be a little low. Could that be the reason? I just figure, I can hear it, I should be able to see it. Lemniscate 06-02-2006, 10:47 AM If bottle pressure is below 1000 you probably won't be seeing much Loco 06-02-2006, 10:51 AM Thats what I was thinking, I guess I need to get that warmer installed. Thanks man! blairellis 06-04-2006, 08:54 AM My cousins windshield cracked from going from one extreme temperature to another really quickly. I might suggest pointing it elsewhere. Do what you want, thats just my 2 cents. Loco 06-05-2006, 12:41 PM My cousins windshield cracked from going from one extreme temperature to another really quickly. I might suggest pointing it elsewhere. Do what you want, thats just my 2 cents. Really huh? Well I'm not really happy with purging it there anyway. It came with a short copper tube that uses a compression fitting to the purge cellanoid(sp?), can I just attach any type of hose (and discard that copper tube) to the controller and run it wherever I want? | ||