gonesurfing04
06-12-2006, 08:22 PM
Ok I just recently swaped my engine with another engine and come to find out I have a b14 and the engine I swapped with was a g20 because of the oil filter and it being a lowport. So I put a turbo on it and it would not run. I checked the codes and it was reading several and on top of that it was also reading the coolent temp sensor. So I went to my old engine and swaped them out and now I go to start it and it floods automatically, and my radiator fans come on like instant. I go to check the codes again and its telling me coolent temp sensor. Will this sensor keep my engine from running thus making it run pig rich and flooding with gas to where I can not turn the engine on? And when I do get it on it runs and blows white smoke out the j-pipe on my turbo. How do I go about fixing this when I already swaped out the sensors? The ecu im using is a jim wolf programed for a 95-96 b14 and my car was a 95 with the 95 engine in it. How do I fix this? Also the ecu im running the codes on is the stock ecu because the jim wolf someone took the knob off to check. Thanks.