what are the TQ specs for the cam caps? I had to change my RAS and I can't find any of my TQ spec sheets.... Hell while we're at it might as well do the whole motor! I gona need it again soon any ways! :D

1.4 ft-lb., then
4.3 ft-lb., then
6.7 - 8.7 ft-lb. (I did 102 in-lb. or 8.5 ft-lb.)

I wouldn't recommend doing this without tightening in the proper order. I don't have the picture to post, but it's (ordered from front of engine to back, with "i" meaning "inside" and "o" meaning "outside" of the engine with respect to the centerline):
3o-3i-4o-4i-2o-2i-5o-5i-1o-1i

The tightening procedure is mirrored from one cam to another, but the "o" and "i" nomenclature still holds true.

Hope this helps,
Andy

cam cap bolt torque is 9lbs. fist do all of them to 4.3lb and then to 9lbs. i did all mine to 10lbs but i had arp cap bolts.

you guys freaking rock... thanks

What order should I do it if I only took off the outside bolts? :confused:

What order should I do it if I only took off the outside bolts? :confused:Um, why would you do that? Did you loosen all of them? If nothing broke, loosen them all and re-tighten per the above procedure.