well a friend of mine has an SER too. he just finished shanging his troughout bearing the one from the clutch, well he finished changing his clutch he drove it for like 10 min and he said that after a little while and when he steped on his clutch it was real soft and when he put it into gear and excelerated it did not excelerate, he had to pull over on the side of the road. the car turns on fine but when he puts it into gear and excelerates the car does not move. also when he leaves it in 1st gear and lets go of the clutch the car does not turn off. its like if it stays in nutral. please help i dont know what it is. i think its either the transmission that got mestup, or the clutch.... but i realy dont have any idea. please help

For future refernce, it's: changing, throwout bearing, stepped, accelerated, neutral, and you're messing some periods and other punctuation marks.

But basically, you're trying to say the power isn't getting to the wheels. And from the sound of it, the motor isn't connected to the tranny (power wise). I take it he didn't touch the clutch at all when he changed out the throwout bearing? If that's the case, the input shaft connecting the tranny to the motor may be no good. Or the axle splines are no good. Or the axles broke. There are probably a couple other possiblities. His only option really is to take the tranny back off.

the car was driving fine for a while. then it just stopped accelarating. thanks for the corections. what is the "Input Shaft"

For future refernce, it's: changing, throwout bearing, stepped, accelerated, neutral, and you're messing some periods and other punctuation marks. .


just had to do it, its spelled reference, and missing. :biggthump

jajajaja thanks SuperblStalion!

just had to do it, its spelled reference, and missing. :biggthump

hahahahaha... punk :tongue: But hey, I only missed one!

bump