Ok peeps the sensor (2 screws hold it in place) that goes on the on the top section of piping of cai how do i go about getting a tight fitment

any help would be appreciated

thanks
(sorry if it has been asked before)

andy:)

Is your car a '98 B14?

its a 97

I take it that the two screws are not holding in place very well. What about trying some silicone sealant.

thats what i was thinking but wanted to see if there where other option
thanks for your help :D

My screws held tight in place without any trouble. I was wondering if it would stay without the hole being threaded or a bolt on the other side, but it seems to be working fine. I wouldn't worry about it, as long as the sensor doesn't come out if you pull on it.