I have a mint SR20ve engine for sale. This engine was in my 92 SE-R for less than 5,000 miles and ran like a dream. The car got totalled by a BMW M5, but the engine was undamaged and I drove it home. When I bought the engine, I took off the valve cover and both oil pans, it's spotless inside. At the same time, I drilled and tapped the lower pan for a temp sender. Both pans were resealed with ultra grey. I had 16ve cams in it, but they are sold and the engine will have a set of 20ve cams and the valve cover will be freshly sealed. I will leave the valve cover off so prospective buyers can inspect the engine.

I'm going to include the modified B13 distributor, coil bracket, solenoid connectors, and coolant hose adapter, basically everything you need to get it into your car. I'll throw in the power steering pump with modified bracket, and a low mile belt, but no alternator.

I have VDO Vision gauges and senders as well. There's a oil temp sender in the oil pan, a water temp sender in the coolant neck, and an oil pressure sender on a Nissport adapter. It also has a 16ve valve cover on it.

There's a Fidanza flywheel, JWT pressure plate and 2001 Nissan disc on it. I will pull the clutch and take pics of the disc, but it operated flawlessly and I did not beat on it. These will be priced seperately, but I won't have pricing until I pull it off the engine for inspection.

I would prefer to sell everything together, but if someone wants just the engine, I'll sell the rest seperately, but I will not sell anything until the engine is paid for. I'm not in any rush to sell, so please don't waste my time with lowball offers. I have an engine hoist and can put the engine into whatever you bring to pick it up. By the way, SR20's fit quite nicely into the rear hatch of an NX. :)

Engine - $1,200 PICKED UP ONLY (Ronkonkoma NY 11779)
VE Maf with pigtail - $50
Calum ECU with VE program (runs mint) $100
MSD 8969 $75
VDO Vision 300* oil temp, 100psi oil pressure and 250* water temp gauges with sensors already mounted $75
Nissport adapter $35
B13 2 gauge pillar pod $25
Prothanes in mounts $100

I may have a full 3" B13 SE-R exhaust and a lowport Hotshot B13 CAI for sale with this.

I can also install this engine in your car. PM me for pricing.

Here's a link to the installation writeup.
http://www.sr20forum.com/showthread.php?t=114313

And the gallery of the engine
http://sr20.net/v/chriscar/VE-Install/

This was the last good shot of the engine before my baby got wrecked. :(
And no, that's not beans in the funnel, it's coolant vibrating at idle with Prothane mounts!
Current pictures will be up tomorrow.

http://sr20.net/d/2144-2/abb.jpg

I'm more than happy to discuss this on the phone if you like, my number is 631-793-3394.

This is also posted over in the Normally Aspirated Parts category. I'm going to close this thread, please reply to the other one. I don't want to have 2 open threads, it gets too confusing.
http://www.sr20forum.com/showthread.php?p=1656255#post1656255

C

Wow, everyone wants the ECU. It's the standard Calum ecu, without integrated Consult.

As stated in the ad, I'm not selling anything until the engine is sold and paid for. Whoever buys the engine gets first crack at everything else.

C