^^^well look at that!!!! There yah go so we should have np getting the clutch/pp/fw setup...I have the JWT setup which is 250mm but it had machining done to it to clear BH.

I have not seen or at least anyone mentioned it doing in a B13 chassis. Give me the width of the frame rail to frame rail in 3 diff points so I can compare it with the B14 chassis, since it clears.

I'll have something for you this weekend, I assume you want the widths from closest to the rad support, halfway, and near the firewall?

It should fit. I'm actually making flywheels for this conversion. Going to allow running a 240SX 225mm clutch. It will ba nice aluminum flywheel, with a heat plate like JWT or Fidanza.

When can we expect these Greg? You may be my one-stop shop for the rest of the necessary parts :p

I'll have something for you this weekend, I assume you want the widths from closest to the rad support, halfway, and near the firewall?



When can we expect these Greg? You may be my one-stop shop for the rest of the necessary parts :p




Yup those widths will be fine, I am pretty sure it will fit since Greg said so.:D


Also Greg will be the man to get all your parts, that is where I get most of my OEM stuff from.:D

The prototype is supposed to be ready any day no. It will be tested and then the production pieces will be run. Realistically, 3-4 weeks.

Greg, whats the current status of bellhousings, i.e. wait times etc.

I have 1 bellhousing, looking for a good home. Brackets are on order as are additional bellhousing. I would encourage someone to jump on the bellhousing. It guarantees them 1st bracket that comes in.

so i've read through all 18 pages of this, very good write up guys. i'm a lil sad that this still hasn't been done in a P11. i've found the bellhousing i need and i have all the other parts ready to order through a friend of mine that does wholesales, so i might pull the 5-spd off and look at just how much of a bitch this is gonna be to put up on a P11.

thanks for all the info guys

I currently have 2 bellhousing/brackets sets ready to go.

those sets fit the P11?

yessir!

pm me *** more info if you wouldn't mind sir? i'm kinda really stupid when it comes to these things, i'm still trying to learn as fast as i can.

Greg,

Any updates on the new flywheel? I'm still torn between this and the B15 lsd 5speed. If I can figure out what I need to get this 6-speed swap to work I can further base my descision. I am still considering the 6-speed in my 1.8L B15+GTi-R and want to know what this flywheel is going to be like. Thanks bro!

Gil

Anyone have this setup in a P11 yet? What was the total cost?

I've got a tranny available if anyone needs one...

clicky (http://www.sr20forum.com/mechanical-oem-part-outs/234685-fs-04-spec-v-6-speed-lsd-tranny-w-goodies.html)

I bumped the thread for a brother...

thanks greg, i'll call you next week about the window seals and some other stuff.

bump, checking status of the flywheel.

any updates??????? anyone get any more info about a p11 swap?

whats a ballpark price going to be for that flywheel Greg?

any updates??????? anyone get any more info about a p11 swap?

P11 has been down on g20.net

whats a ballpark price going to be for that flywheel Greg?

IIRC $600