PNWser
11-14-2006, 05:36 PM
I am selling my sentra! I have already removed the engine (was sr16ve) and this is what the car has now:
Full es bushing kit (less than a week old)
KYB AGX (20k miles)
Hyperco springs (350F250R dunno which batch)
FSTB
ST swaybars
NX brakes in front, calipers are 40k old, pads/rotors have about 5k-organic pads
metalmasters/rotors in rear were replaced 15k ago.
3 of 4 brake lines are stainless (drivers front came unattached from strut + was damaged, has stock line, never replaced it with another stainless line)
Comes with SR16VE flywheel and clutch setup in good shape.
ES motor mounts, shifter bushing, Optima redtop in the trunk with circuit breaker
autometer procomp mechanical water temp and oil pressure, stainless braided oil line from engine to gauge. In lotek "A" pillar pod
Tranny has 5th gear pop out but makes no bearing noise and shifts great 1-2-3-4
Interior is a 6/10 Exterior is a 6/10
I bought this car with 148k on the clock and it now has ~220k. I swapped several engines in and out, did wheel bearings, ball joints, etc, when it was needed.
The chassis is in strong mechanical shape, the interior and exterior need some love, all she needs is an engine ( and a 5th gear kit!)
I'm asking 1500. Clean title. "ruby red pearl" exterior
I'll install an engine in the car for $200 IF I get 1500 for the chassis. I can source an engine for a fair price and I can install the engine as soon as I get it.
If you are serious I can provide pictures.
PM me for my cell # or email me or PM me for more info.
Full es bushing kit (less than a week old)
KYB AGX (20k miles)
Hyperco springs (350F250R dunno which batch)
FSTB
ST swaybars
NX brakes in front, calipers are 40k old, pads/rotors have about 5k-organic pads
metalmasters/rotors in rear were replaced 15k ago.
3 of 4 brake lines are stainless (drivers front came unattached from strut + was damaged, has stock line, never replaced it with another stainless line)
Comes with SR16VE flywheel and clutch setup in good shape.
ES motor mounts, shifter bushing, Optima redtop in the trunk with circuit breaker
autometer procomp mechanical water temp and oil pressure, stainless braided oil line from engine to gauge. In lotek "A" pillar pod
Tranny has 5th gear pop out but makes no bearing noise and shifts great 1-2-3-4
Interior is a 6/10 Exterior is a 6/10
I bought this car with 148k on the clock and it now has ~220k. I swapped several engines in and out, did wheel bearings, ball joints, etc, when it was needed.
The chassis is in strong mechanical shape, the interior and exterior need some love, all she needs is an engine ( and a 5th gear kit!)
I'm asking 1500. Clean title. "ruby red pearl" exterior
I'll install an engine in the car for $200 IF I get 1500 for the chassis. I can source an engine for a fair price and I can install the engine as soon as I get it.
If you are serious I can provide pictures.
PM me for my cell # or email me or PM me for more info.