just needed to vent....i've got all of my wiring figured out (so i think) for my sr swap into my b14. i'm using a highport engine and harness, so i had to trace each wire of the underdash plugs and use the FSM to figure out what each does. the wiring of the b14 makes no sense to me. in the ga16 model's ecu pin 55 goes to the rear defroster and pin 60 goes to your lighting switch. neither of these pins are in the wiring for the sr. why do they need to be ran through the ecu? i hope my lights still work....if not i guess i will just run them to a switch. pointless thread but like i said, i had to vent.

good luck is all I can say.

If it dont work, you will always think it should have