So I got my header and those DAMN catalytic bolts will not come off!!!!! arrrrgghh!!!
So I went ahead and hacksawed the damn thing off right before the resonator. Now heres the deal. I need to get a 15 inch extension from the header to the resonator.
1)-Can I just fabricate one or does a muffler shop have to do it?
2)-If I can fabricate one how do I make the ends bow out and fit the flanges?

ALL HELP IS HIGHLY APPRECIATED.
I will be attacking this project tomorrow morning.

Use super glue and rubber bands http://laf.cioe.com/~benbobbo/NonCGI/biggrin.gif that should work. http://laf.cioe.com/~benbobbo/NonCGI/wink.gif

------------------
http://www.users.qwest.net/~bkc3/+G20%20stuff/g202.jpg http://www.users.qwest.net/~bkc3/infiniti%20icon.gif
Kris94G20™
"clears and stickers, the best bang for your buck"
The Beginning. (http://www.users.qwest.net/~bkc3/home.htm)

<font face="Verdana, Arial" size="2">Originally posted by kbslacker:
Use super glue and rubber bands http://laf.cioe.com/~benbobbo/NonCGI/biggrin.gif that should work. http://laf.cioe.com/~benbobbo/NonCGI/wink.gif

</font>

You dork!! http://laf.cioe.com/~benbobbo/NonCGI/wink.gif
I tried that last time!!

how about duck tape?

94Red;

I did the same thing on my '93, as 149,000 miles are brutal on the cat bolts. I had to have mine towed to my exhaust shop, and the guy who owns it fabricated the piping and welded it.

Charged me $26.00, a bargain in my book.

------------------
Greg Perry, '93 SE-R w/ 149,000 miles, JWT pop, header, ProActive
clutch, ST bar, NOS direct-port 75hp, Autopower 4-point roll bar/harnesses.
14.10@99mph 1/4 mile, 8.95@76mph 1/8 mile, 1.98 60-ft.
http://members.home.net/herdinsider/carpics/serinpitssmall.jpg
My SE-R page, with videos (http://www.geocities.com/herdinsider/serpage.html)

i would think the best thing to do is let a professional at a muffler shop do the work. that is unless you own an arc welder.