I am a little concerned with how close my master cylinder is to the intercooler piping that runs to the TB. Did any of you have clearance or inreference issues? My piping is only 1-2mm away from the Master cylinder.

Also the vacuum hose that runs from the top of the charcoal canister, do you have it running to the bottom of the TB? There is a small valve type device below the TB, do you have the charcoal canister running to the bottom of this valve and then the top of the valve running to the TB. Is this little valve part of emissions, I have seen this vaccum hose run different ways.

Thanks

I had the same clearance problem, and I've just cut little bit of the rubber hoses that is between the intercooler and the piping that go to the TB. (you just need to cut a litte "[" on the hoses where you see the "block" on the TB Piping)