I am trying to investigate all my possibilities since my spun bearing.

I found a nice motor near by but it is low port.
Will this be any problem in an NX2000? Will the high port harness fit ok?

Thanks

--Eric

i have the same problem I found very nice motor with low port and mine is high port the same as in your's 2000nx

so the same problem :(

the harness wont fit, the ecu wont fit, so you will need the scehmes of harness of the low port and the harness scheme of high port for fixing the wires in right way. The problem is I cant find the schemes :confused:

hehe i have the same problem but except i have my lowport motor installed all ready. Its too much of a pain to get both wiried up right.

Guys, you need to search this. Questions like these have been asked quite a few times, some even as early as last week.

If the low-port is coming off an OBD-I car, you will have no issues, with either the harness or anything else. If its an OBD-II low-port, you will need to swap out the sensors and use the ones from your high-port to make it work.

For directions on what to do with the OBD-II low-port go here:

http://www.sr20forum.com/showthread.php?t=14904&highlight=obdii+motor+obdi+car