|
420sxDET 02-25-2007, 01:02 PM Hey, I was wondering how many mounts does a FMIC usually have? I screwed up 1 outta 3 of my intercooler mounting. Im thinking of chopping off the bad mount in the meantime and fix it after my car is running again, and when I have access to the TIG welder again Will 02-25-2007, 01:12 PM it depends, how well is it on there? I have two screws holding mine into my bumper support. B14 Se-Rious 02-25-2007, 01:20 PM Modified bumper support to fit intercooler, than lines it up and drilled 2 holes through it and used bolts goin through it like so. http://i110.photobucket.com/albums/n100/b14serious/S3010188.jpg coach 02-25-2007, 04:17 PM You are fine, the pipes will keep ti from going back and forth and the two mounts on top will hold it in place. BRent 420sxDET 02-25-2007, 04:27 PM it depends, how well is it on there? I have two screws holding mine into my bumper support. Well, I am using one of the hood latch bolts with about an 3/32 piece of alluminum with a grommet. The bottom I used 3/32 also, but the holes arent matching up very well. I might jsut redo it. I was stupid and welded on the tabs first in the general area. I was stupid and should have drilled the holes first and then figured where the tabs go on the intercooler. I was probably hungover when I did that. I should get to work griding down my welds. I'm still learning coach 02-25-2007, 04:54 PM lol, good deal man! Brent | ||