|
JohnnyCongo 05-26-2002, 12:33 PM hey im about to install my momo steering wheel and hub adapter and noitced the directions are in german. I have a fsm for taking the stock steering wheel off and I dont think it should be too hard but I was wondering if anyone had some specific pointers or know of an online source for realy good and thourough directions. Also does it take any fabrication or does it go in pretty easy? tpeele 05-26-2002, 05:37 PM http://www.sr20deforum.com/showthread.php?s=&threadid=9831&highlight=momo+horn Tim Geo 05-27-2002, 01:11 AM Originally posted by JohnnyCongo hey im about to install my momo steering wheel and hub adapter and noitced the directions are in german. I have a fsm for taking the stock steering wheel off and I dont think it should be too hard but I was wondering if anyone had some specific pointers or know of an online source for realy good and thourough directions. Also does it take any fabrication or does it go in pretty easy? Installing the MOMO adapter and wheel is pretty simple. You'll figure it out pretty well. There is one lead for the horn that you hook up to the horn button. No big deal..... Unless you want to retain cruise control. :D I've done it on my G20 and will be doing it for my SE-R when I get around to getting it back on the road. I'll document it then. :) Katana200sx 05-27-2002, 11:07 PM just wanting a second opinion on this...i was told a hub from a s14 will work on my b14...is this correct or is there another hub that i need? just wondering bc i have not seen a momo hub for a b14. hey808 05-28-2002, 01:56 AM We have used Momo hubs for the NX2000's on B14's. If the car it is going onto has an airbag, then you're going to have to first be very careful, then find a way to hook up the horn. Make sure you know what you are doing before attempting to work with an airbag-equipped car since there is the chance that it can deploy. Even if you remove the driver's side airbag, be careful because there is still one on the pass. side. The horn trigger wire is located in the airbag loom, so don't monkey around if you are unsure of what you are doing. Read: Very Dangerous! Here's a helpful site http://importnut.net/steeringswap.htm Geo 05-28-2002, 07:14 AM Originally posted by hey808 We have used Momo hubs for the NX2000's on B14's. If the car it is going onto has an airbag, then you're going to have to first be very careful, then find a way to hook up the horn. Make sure you know what you are doing before attempting to work with an airbag-equipped car since there is the chance that it can deploy. Even if you remove the driver's side airbag, be careful because there is still one on the pass. side. The horn trigger wire is located in the airbag loom, so don't monkey around if you are unsure of what you are doing. Read: Very Dangerous! Yep. My father-in-law ran the service department of a large car broker and one of his guys got a broken nose for his efforts when he forgot to disarm the airbag and it went off while he was working on it. | ||