Hello All,

IM looking to purchase a complete JDM ( egr less ) intake manifold.

Complete as in ( upper and lower ) dont need sensors etc injectors. Will all my USDM parts swap over for installation?

Im just looking to eliminate all the EGR / BPT /AIV Crap & Clean up my engine bay.

Thanks

I got one for $60 shipped

Will all my USDM parts swap over for installation?


Yes

C

Chris,

Is this worth it to clean up the engine bay? And get rid of all that mess. Im not worried about inspection or any of that just getting rid of the non needed stuff.. A/C , ABS, EGR etc

Andreas,

I have a close friend that is compenent honda engine builder is there any room for improvements in this manifold ie: he use to take GSR Manifolds and totally rework then and put them back together so if theres room for improvement i would like to do this.

Chris,

Is this worth it to clean up the engine bay? And get rid of all that mess. Im not worried about inspection or any of that just getting rid of the non needed stuff.. A/C , ABS, EGR etc

Yeah, ditch it all if you're turning the car into a toy. The engine bay will be allot cleaner and easier to work on. Here's what you need to know re: ABS removal.
http://www.sr20forum.com/showthread.php?t=157899

C

Awesome, Yep ditching all of it and have your write up all bookmarked and ready to go. I figure all that crap should pull close to 75lbs off the car also will be relocating my battery to the trunk and I saw your thrifty write up on that as well. I will be purchasing a battery box though like Shcu...

Anything else that can be removed up there? Not removing powersteering.

I think once the A/C is out it only requires one fan. Was thinking of getting a slim pusher fan and putting it on the oposite side of the rad. I think i read people do that too. This is so much fun again.