Sorry for the cross post but no one responded in the Technical Forum and I know a lot of people have used this setup before so I'm trying the Turbo Forum. For any of you that have installed this combo, I have a question. There is a metal clip near the top of the injector and I didn't know what it was for or how it was supposed to be used.

My best guess is it is there just to set the distance that the injector goes into the fuel rail. Is this correct? Do I just push the injector up into the JWT fuel rail until it reaches the metal clip?

Might as well ask the next question: do I then push the bottom of the injector through the stock rubber insulator until snug and then bolt downt the fuel rail?

Thanks for any advice!

Steve

That's what I did, so if there is a better way to do this, please let us know.