Hey guys,
I'm helping a friend do the S13 swap into his 89 240sx, and we're having some problems with the wiring harness. It looks like its supposed to be routed thorugh the drivers side and the hole for the engien harness is on the passenger side...can you use the KA wiring harness and plug the SR ECU into it? I need some help here guys...its no fun....the engine is in should we take it out and put the plugs for the sensors on and see how it lays in the engine bay...? I need some guidence...:confused:

You need to cut and extend some of the wires to make it fit. Plus you would have to splice some wires together too. The wireing is the hard part. You might want to check out www.heavythrottle.com, the site will help you out alot. The Sr wiring is for the JDM chasis (i.e. right hand drive) so it would lead to the right hand side.

Duc Tran
www.boostfactor.com

Originally posted by Fast240-T
You need to cut and extend some of the wires to make it fit. Plus you would have to splice some wires together too. The wireing is the hard part. You might want to check out www.heavythrottle.com, the site will help you out alot. The Sr wiring is for the JDM chasis (i.e. right hand drive) so it would lead to the right hand side.

Duc Tran
www.boostfactor.com

Thanks Duc! This is Ryan, I was the one who was stayin with James for a week or so...how you been man? That web-site helps out a lot! Were worried about the extra plugs by the battery fuse box...any other advice? :confused:

try asking the many sr people on freshalloy in the advanced section 240. they will be able to help u out as well.

If you know somebody with a SCC magazine from about 2 months ago, there some good wiring help in there also. It explains the fuse box wiring too.