Up for sale is 1 Bare head from a Lowport sr20de non RR.

This head has around $1000 of machine work done to it.
a list of what it has done:

True flat with PCD cutter

Intake side multi angle valve seats

Radius ground exhaust valve seats

Bronze valve guides on the exhaust side

Port and polish

New Valve stem seals

The exhaust valve guides are blended to the roof of the exhaust port.


Here are some pictures
http://i26.photobucket.com/albums/c126/robboser/P1010028-1.jpg
http://i26.photobucket.com/albums/c126/robboser/P1010038-1.jpg
Intake side


http://i26.photobucket.com/albums/c126/robboser/P1010042-1.jpg
http://i26.photobucket.com/albums/c126/robboser/P1010040.jpg
Exhaust Side


http://i26.photobucket.com/albums/c126/robboser/P1010046-1.jpg
The Exh. Valve guides are blended into the port.

http://i26.photobucket.com/albums/c126/robboser/P1010045-1.jpg
The valve stampings


http://i26.photobucket.com/albums/c126/robboser/P1010023-2.jpg
There is a chip taken off the left side cam journal area, but it has been throughly checked out and the head is in 100% great working condition with no problems. The chip is not an issue.


[B][COLOR="Red"]
This is a bare head with cam caps in need of a linebore. Keep in mind that this head has over $1000 of machine work done to it.

bump

bump, this is a nice looking head, and I have the documentation from the machine shop I had it at.

Bump for good head. I'd buy it if I had the $$$.

thx:D

bump.

bump. anyone make an offer.

To hard to swap? Are you kidding me. COME ON MAN!!! Where is your sense of adventure. Buy a keg.. have some buddies over and go at it.

Not a matter of being too hard as much as it is being a matter of time and money available. I've got enough going with my High CR engine build. Ready to swap in :biggthump. Just need an ecu and a spare car so I have to fix my dads rx7 before I can do it.

bump, I will do trades if anyone has anything I am looking for. JWT ECU, new clutch and flywheel for a B13 sr20, throttle body, Money.

why dont u use this head for your high compression build ???

bump.

stratton.

Its a B14 head and the motor I am building is for a B13.

Has a different IM and head setup.


I would if I could.


Bump, someone must be able to use this.

94 B13's came with the lowports. I would put this head for your high comp. build imho.


BTW Bump:D

I have a 93 sr20 though and everything is already together (plus I put about a grand into the head that is on there right now anyways), and I am just waiting for an ECU now :biggthump
It would be more work then it is worth to switch over to this head.

whats up man still have the head? whats missing from the head? what part md u from? hit me back up interested looking for head

I have the head. Right now the head only has valves, valve springs, and valve stem seals on. I beleive that I have enough cam caps and everything else that I could peice it together and throw a pair of 93 highport cams in there if you want.

bump

Bump..which shop did the work?

the work was done by Jim's Performance Machine in Catonsville.
He was highly recommended, and does a lot of work at Ladds speed shop in Elkridge.

bump, anyone make an offer. I want to get at least enough to buy myself a JWT ecu .

Bump for Jim's performance