Pdawg
05-20-2007, 08:01 AM
hey guys, just wondering if someone has installed a haltech E6X on there SR20?
my main question is about the crank angle sensor.
http://i104.photobucket.com/albums/m164/petervel/IMG_2799.jpg
see in this picture we wired up the yellow to the white (trigger) on the sr and the black inside the insulated wire to the green. but then we did not use the red and light blue for grounding we used the black and the grey/red, am i supposed to have used the other two wires in the four core provided from the haltech? so if someone has hooked up an E6X to a sr your knowledge here would be greatly appreciated. thanks
pete
my main question is about the crank angle sensor.
http://i104.photobucket.com/albums/m164/petervel/IMG_2799.jpg
see in this picture we wired up the yellow to the white (trigger) on the sr and the black inside the insulated wire to the green. but then we did not use the red and light blue for grounding we used the black and the grey/red, am i supposed to have used the other two wires in the four core provided from the haltech? so if someone has hooked up an E6X to a sr your knowledge here would be greatly appreciated. thanks
pete