I need to find a downpipe to fit a 1993 Sentra SE-R with a SR20det conversion. The turbo is a Garrett t25. I have taken the car to local exhaust shops. They are pointing me to a manufactured pipe rather than trying to fabricate a downpipe with their pipe mandrels. I guess the angle is too sharp for 3" exhaust pipe.

Check out jgycustoms.com That is where I got mine and I am running 3" from the turbo back. They should be able to accomodate for either up or down turbo.

fu*k JGY! Read this about them first before buying anything from them. http://www.sr20forum.com/buying-selling-experiences/199460-another-victim-jgy.html

Then take you busniess to Serban at: http://www.sr20forum.com/gofastdepot-com/ (check out the VRS catbacks and downpipes thread for what your looking for)

He is a supporting vendor of the forum and you don't have to worry about if you will get good parts from him or not. The customer service of GFD is top notch. :biggthump

Mike

I know they have a pretty bad rep and severe issues with customer service but they eventually got it right with me. Hell, they are the reason I am running 3" from turbo back. I had originally ordered 2.5" and they said it was in stock and should have it in a few days. Two weeks go by and nothing. So I call & they say they are out of them and nothing was sent to me. So they wound up sending me the 3" at no additional cost. I have had a couple of other dealings with them that went smoothly though.

I know they have a pretty bad rep and severe issues with customer service but they eventually got it right with me. Hell, they are the reason I am running 3" from turbo back. I had originally ordered 2.5" and they said it was in stock and should have it in a few days. Two weeks go by and nothing. So I call & they say they are out of them and nothing was sent to me. So they wound up sending me the 3" at no additional cost. I have had a couple of other dealings with them that went smoothly though.

:confused: that sounds like a bad exp and ur still liking them?:confused:

I didn't say I was still liking them, they were the only ones I could find that could help me out with a couple of problems I was having.

Get a VRS 3" downpipe from Serban at gofastdepot.com

http://www.sr20forum.com/gofastdepot-com/

it sounds like you are trying to not use the o2 housing off of the turbo. You will have to use that stock piece, or like you said, the angle is too sharp.

Thanks for your help on this.