I am in the middle of swapping a bluebird engine into a 1996 200sx. I have the B14 ecu reprogramed to run with my stock harness and sensors etc.. I went to plug the harness in and I seem to have hit a snag. Almost everything was fine except for some connectors in the back, under the intake manifold. On the SR20DE there is a brace that holds a connector with three small hoses on it, I don't seem to have that on the bluebird. In the same place though, is a different connector with three large hoses coming off it. Also around the pulley side of the engine there are what seems to be an extra connector or two. Someone please help me:confused: , I'm close to done and I want to finish.

sounds like you have run into the egr system don't worry you dont have to plug this in because your bluebird didnt come with one

sounds like you have run into the egr system don't worry you dont have to plug this in because your bluebird didnt come with one

Nice, it seemed like the hoses were going to the canister on the drivers side so I think you're right. Maybe everything is hooked up right then. Thanks:tongue:

actually now that I think about it, what is the sensor that is in the same area as the egr on the bluebird? The one that has three large hoses on it. I don't think I have a connector for that.