Hi gang, I have bought Serban's gauges that I am almost done with modding. He had cut the center hole larger in order to install them. I have used vinyl decals to cover up the center section. (I never did care for the glowing middle anyway) I have cut all the holes out for the clock, trip, etc... but I need to know the center hole size where the needles come out. I could jsut cut a "X" and trim as I install them, but if any of you have these and know it sure would save me some time.

Here is a shot of the gauges on procar's website.

http://www.procarparts.com/productimages/ING-9192SER-REV.jpg

The picture is not seeming to work, sorry please go here to see them. http://www.procarparts.com/store/displaydetails.cfm?pid=ING-9192SER-REV

I will post some pictures this weekend with all the details for everybody. I have heard most other people don't like the centers as well.

TIA,


EDIT: Just thought of something...Is the hole in the center tach and speedo the same size as the fuel and temp gauges? If so I got it.

to install the indiglo gauges you have to remove the tach gauge there is three screws that holds the tach in and remove the black cap on top off the needle and slide the gauges over very carefully remember what i said carefully the first time i tried i have to buy a new cluster. You didn't need have to cut the center hole.

Ralph, dont know if you got it yet, but I am pretty sure the holes were the same size as the ones in the gas and temp gauge.

Good luck with them, and take pics when you're done.