Does anyone have a Factory Service Diagram that shows where all the wires and connectors go in the engine bay? I have almost completed my jdm engine swap, all i like is hooking up the connectors, hoses, and putting the axles on. When I went into this project i saw so many different connectors that i thought that the same connector could not fit on more than one other connector. Turns out, i thought wrong. Several connectors have the same shape and pin numbers. So any help with wire colors under the wire loom would be greatly appreciated as well. I would appreciate if someone could scan and send me a pic of the diagrams as well. Thanks in advance.

The harness should go back in the same place it came from. IDd you swap the old sensors over to the new motor? The only place where I found 2 connectors that were the same was the o2 sensor, and one of the distributor harnesses.

i was told not to swap the sensors that it shouldnt make a difference. i did switch the old distributor onto the new block. I didnt swap the intake manifold either, *** i am not going to use the egr.