I dont even know where to start, i follow the guides and stuff but i am still LOST, i am tryign to use TUNER RT, but nothing, also bikisoft, but i cant even get the info from the calum realtime ecu, i need some REAL help, i had been reading all the post from the calum forums but i dont recieve any info from the ECU, so i cant even know how to start...

i was afraid about having this problems from the very beg, about been lost having the ecu and could try anything, i am running the ve engine with OBD1, and also N60 maf, but when i recieve the ECU i didnt have the N60 yeat so i installed the ecu with the SER normal maf, and actually the car is runing normal(still getting like les than 145whp), but at least the car is running normal, yesterday i recieve the N60 and i installed it but the car is REALLY REALLY MESSED UP with that N60, i follow the JWT install guide, but the car is running really bad, so i installed the SER normal maf again to the car and its runing better... and I also followed the QUICK START GUIDE from callum forum, and i install the bin that That it was suppoused to work the N60, and didnt work...

i really need some HELP plz

if u guys have like pics or some usefull guide i will appreciate

Perhaps the N60 was not properly wired. You might try searching this forum to get the wiring specs (which wire goes where) and double check that. Then you can use a multimeter to check that the MAF is sending the right kinds of signals to the ECU (varies with RPM, ranges from 1-4 volts). After that, make sure that you have the right program installed on your RealTime ECU. I have the Calum classic ECU (pre-RealTime) so I don't know much about the RealTime.

hey thanks alot bill, i will double check that, and post some new info in the night, thanks alot, and btw by any chance do u know some1 that maybe have the real time, so i can ask him some questions ??

thanks

What questions do you have?

Cheers-
Erich