|
NaLLa8705 10-07-2007, 11:26 PM Installed these in my motor, ran for 300 miles, popped a head gasket, and didnt re-install when i rebuilt the head. Looking to get $50 shipped... The are in VERY GOOD condition... no problems at all with them!!! Paypal to NaLLa8705@hotmail.com wkdstnz 10-08-2007, 08:16 PM are these the same one for the GTiR N14 motor as well NaLLa8705 10-09-2007, 12:58 AM I THINK so.... but i would double check first... maybe someone will chime in NaLLa8705 10-09-2007, 11:14 PM Anyone sure? NaLLa8705 10-12-2007, 12:54 AM Come on guys... i know someone wants to keep there rockers from flying off!!! NaLLa8705 10-14-2007, 11:24 AM bump wkdstnz 10-14-2007, 09:33 PM JWT says that if not revving above 7400 rpm which is where they set the rev limiter, these are not necessary and most of all, if you do over-rev the motor, by accident I'm sure, and the rocker comes off, without these, you can put the rocker back on with minimal time. When the rocker stoppers are installed and one comes off, it is a pain to reinstall plus with the rocker stoppers in place if one comes off due to over-rev, if will lodge itself into the valve spring. The jist of all of this is as follows: When installing bigger cams ensure you get the appropriate rocker shim and keep your revs below 7400rpm. Per phone conversation with JWT on 10/12. Johnny wangwang 10-15-2007, 04:34 PM JWT says that if not revving above 7400 rpm which is where they set the rev limiter, these are not necessary and most of all, if you do over-rev the motor, by accident I'm sure, and the rocker comes off, without these, you can put the rocker back on with minimal time. When the rocker stoppers are installed and one comes off, it is a pain to reinstall plus with the rocker stoppers in place if one comes off due to over-rev, if will lodge itself into the valve spring. The jist of all of this is as follows: When installing bigger cams ensure you get the appropriate rocker shim and keep your revs below 7400rpm. Per phone conversation with JWT on 10/12. Thats all great and good and everything. But why did you feel the need to post this in his for sale thread? Obviously if the person is looking for rocker arm stoppers chances are that they are planning on revving the motor higher then the 7500rpm redline....so basically everything you posted has nothing to do with this fs thread...:confused: These are pretty much brand new people. The car literaly ran for 300miles (I think it was less lol but hey its his car so im not going to argue) and then we took it all apart again because of the head gasket being blown wkdstnz 10-15-2007, 11:35 PM I agree that it was a piss poor way of getting my thoughts out. PM sent. I was looking for a few firey responses proving there worth is all. NaLLa8705 10-17-2007, 11:52 AM bump.... NaLLa8705 10-19-2007, 12:34 AM bump NaLLa8705 10-23-2007, 12:48 AM ttt.... NaLLa8705 10-29-2007, 11:36 AM week later bump | ||