Just worry about that case cracking if anything. Slicks will do wonders. I am hoping I can trap some times like you or even better on 15psi and race fuel with my T25. I want to see some at least mid 12's with DR's.

Thats my goal also once I get slicks and a stronger pp.

I am hoping my clutch decides to grab good. What pressure plate are you running now?

I am hoping my clutch decides to grab good. What pressure plate are you running now?

Believe it or not I am running one of those xtd clutches (stage 3) and its holding pretty well, but I am finally pushing it to its max now and it needs to be upgraded.

Wow man, thats pretty impressive. I noticed my clutch is slipping only when I slam the gears but if I granny shift, it will grab and hold up to 18psi.

you using jbweld as a block filler tbags?

its a way to re-inforce the trans diff. that along with some redline helps protect ur tranny from sudden 7k launches or just a plain ol' turbo upgrade

its a way to re-inforce the trans diff. that along with some redline helps protect ur tranny from sudden 7k launches or just a plain ol' turbo upgrade

write up?

write up?

Ditto on that write-up.

I am also going to replace my driver side axle before I do the slick thing because the boot has slipped back and you can see all the grease. Better safe then sorry, besides they are orginal axles with 173,000 on them.

Ditto on that write-up.

I am also going to replace my driver side axle before I do the slick thing because the boot has slipped back and you can see all the grease. Better safe then sorry, besides they are orginal axles with 173,000 on them.

theirs a couple of write ups but their old. when u drop the trans just fill in the diff sides holes with jb weld..its took me 1hr to do and mau=ybe 6-7 tubes.:tongue: i did the same mod to my g20 whe i swapped in the jdm for future references..plus my g20 trnas has around 180k on her:eek:

http://www.atl-sr20.com/howtos/NX1600DET/pictures/parts/tranny%20welding.jpg
searched some and found this pic..i can also have a meineke weld this same part..i rather spend $50 or so and use jb weld

thats' impressive for a t25.. I got a bbu12 with fpr, walbro 255 fuel pump, factroy 3z 370cc injectors, small fmic, hks bov, 10 psi, apexi asfc, pulls strong but I dont know what my times are...want 13...

thats' impressive for a t25.. I got a bbu12 with fpr, walbro 255 fuel pump, factroy 3z 370cc injectors, small fmic, hks bov, 10 psi, apexi asfc, pulls strong but I dont know what my times are...want 13...

you will definitely get a 13 with no problem whatsoever.