i was just wondering what pistons and rods are you guys that have a 150 or 200 shot using? considering building a de to handle a 200 or a 220 shot.

Are you doing just nitrous, or are you doing nitrous along with a turbo also?

just nitrous.

factory U.K. 10:1 pistons. stock rods. jwt 100shot program. 370cc injectors. nismo fpr, and some JWT S4's. you are now the man of the land.

sorry now is see that you were asking about a 200 shot. try some factory det pistons, or you can go with aftermarket. as far as rods go you will have to get aftermarket, like crower or pauter.

I would go Eagle rods with Wiseco low compression pistons. Probably 8.8 or 9 to 1 compression ratio.

would i need to sleeve the block?

would i need to sleeve the block?

Nope, and run 10:1 with wiseco pisotns ans eagle rods.

9:1 safer, but 10:1 will be fine with a good tune.

Is this for a DD car or race car?

Matt

If you're only doing 340 HP total, you should be able to use the stock 9.5:1 pistons and rods from a DE.

This is with progressive control of course.

Is this for a DD car or race car?

Matt

race car.

factory U.K. 10:1 pistons. stock rods. jwt 100shot program. 370cc injectors. nismo fpr, and some JWT S4's. you are now the man of the land.

This is very similar to a build I want to do how much power should that set up make?

im running 75 soon to be 100 shot on sr16ve pistons in a DE block on stock injectors, i have a safc set to stock but im going to tweak it soon